Directions For Use:
- Cleanse the eyebrow area with an oil-free makeup remover.
- Degrease the areas with Bronsun Saline Solution or Bronsun Shampoo. The use of scrubs and peels for preparing the eyebrows is prohibited.
- Apply zone gel on the skin around the eyebrows, avoiding contact with hairs.
- Comb the eyebrows with a disposable spoolie, creating the desired direction and shape. To avoid creases during the long-term brow perm procedure, consider the natural direction of hair growth when applying the compositions.
- Apply a thin layer of composition #1 Brow Lift on dry eyebrows. The average exposure time depends on the density and thickness of the hairs. Timings vary from 2-15 minutes. It is always recommended to monitor the condition of hairs during the exposure time.
- As the exposure time is over, completely remove composition 1 with a wet cotton pad, moving in the direction of the hair growth. Carefully adjust the shape with the spoolie, creating the desired direction.
- Apply composition #2 Brow Sculpt on the eyebrows, spread along the hairs, carefully creating the desired directions. The exposure time for composition 2 is the same as you did for composition 1.
- Once the exposure time is over, completely remove composition 2 with a wet cotton pad.
- Carry out the tinting procedure with Bronsun dye. The exposure time for dye during the long-term brow perm procedure must be reduced from the one stated in the instructions to 2-5 minutes, depending on the chosen shade and desired effect.
- As the exposure time is over, remove the dye with a wet cotton pad.
- Apply composition #3 Brow Essence on the dry eyebrows with a spoolie, creating the desired shape. Do not rinse.
Timings:
- Thin, porous hairs: 2-4 minutes
- Hairs of medium thickness, and hairs that have been previously chemically treated: 4-6 minutes
- Coarse, dense, thick hairs and hairs that have not been previously chemically treated: 5-15 minutes
Patch Testing:
Perform a sensitivity test 24-48 hours prior to the procedure, even though a client has already used these products.
To perform the patch test, apply a small amount of all 3 compositions to the inside of the elbow or behind the ear and wash it off with water after 30 minutes.
In case of itching, irritation, swelling or redness during the exposure time or within 24-48 hours, the use of the product is prohibited. Patch testing is an important precaution, however, keep it in mind that even after completing the test, the client may experience an allergic reaction. Please warn the client about the necessity to consult a doctor if there is any doubt about a possible reaction to the components.
Additional Information:
- For professional use only.
- Run a sensitivity test before use. In case of an allergic reaction, consult a doctor.
- Avoid contact with eyes. Rinse eyes immediately if the product comes into contact with them.
- Keep out of reach of children.
- For intended use only.
