How to use:
1. Clean the eyebrow area from makeup and impurities using an oil-free cleanser.
2. Apply a protective cream or rich moisturizer around the eyebrows, avoiding areas you plan to lighten.
3. Mix BRONSUN eyebrow lightening powder and BRONSUN 3% oxidant cream strictly in a 1:1 ratio in a non-metallic container. Stir thoroughly until a smooth creamy consistency is achieved, and let the mixture sit for 30–120 seconds to allow the components to fully interact.
4. Using a brush, apply the resulting mixture to dry eyebrows. The exposure time of the lightening mixture is 5–15 minutes, depending on the desired level of lightening. It is recommended to check the lightening process every 2 minutes!
5. After the time has passed, thoroughly rinse the lightening mixture off the hairs and skin with water.
6. If necessary, proceed with the tinting procedure using BRONSUN dye. Mix BRONSUN oxidant cream and BRONSUN dye according to the dye instructions. The exposure time of the dye after eyebrow lightening should be shortened from the standard time, depending on the chosen shade and desired effect.
7. After the procedure, it is recommended to apply a moisturizing cream to the skin around the eyebrows, avoiding contact with the hairs.
PRECAUTIONS:
For professional use only. Perform a sensitivity test before use. In case of an allergic reaction, consult a doctor. Avoid contact with eyes. If contact occurs, rinse immediately. Wear suitable gloves. Keep out of reach of children. Do not use for purposes other than the intended use of the product. Do not inhale. Avoid contact with skin during repeated application. Do not apply the lightening product if there is: skin damage, irritation in the application area, any kind of rash, flare-up of skin conditions in the treated area, inflammation or diseases of the eyes or mucous membranes. Do not use if the eyebrows were previously colored with natural dyes or underwent brow lamination or styling on the same day. Do not use the mixture after a hot bath or steaming the application area. Avoid exposing the treated area to direct sunlight for 24 hours after application.
Ingredients:
Potassium Persulfate, Sodium Metasilicate, Sodium Silicate, Sodium Persulfate, Glucose, Ammonium Persulfate, Magnesium Stearate, Hydrolyzed Corn Starch, Sodium Lauryl Sulfate, Paraffinum Liquidum, Hydroxyethylcellulose, Silica, Disodium EDTA, CI 77891
